Follow standard safety precautions when applying Camo Form® to weapons. Make sure weapon is not loaded, confirm that the safety is in the “on safe” position and point the barrel away from you at all times. Camo Form should not interfere with the safety or action of a firearm. If this occurs after application, remove Camo Form and reapply in a manner that allows for the proper function of all parts.
Basic Application Instructions:
(1) Start by holding beginning of roll in place on object.
(2) Begin wrapping at barrel or stock and wrap towards center of weapon.
(3) Always begin by wrapping Camo Form one full wrap on to itself, then continue wrapping the object.
(4) Then stretch and wrap Camo Form
(5) All subsequent wraps should overlap by approximately ¼ in.
DO NOT WRAP MOVING PARTS. DO NOT COVER FLASH SUPRESSOR VENTS, PORTS OR CARTRIDGE EJECTORS.
For best adhesion apply in temperatures above 40° F (5° C).
Special Applications
(1) To cover ‘unwrappable’ areas, cut and use strips of the Camo Form to cover the sides of the weapon via the bridging technique.
(2) Anchor these pieces with an additional wrap of Camo Form on either side.
(3) For small moving parts such as scope dials, cut small pieces of Camo Form to separately wrap small parts to allow them to move freely.
(4) When wrapping the barrel, anchor Camo Form on the front site base.
(5) Wrap back of butt stock to avoid shoulder slippage (see basic instructions), or leave back of stock unwrapped to allow weapon to slide into position on shoulder.
Camo Form Tips
• Use Camo Form to create a cheek pad.
• When finishing a wrap, anchor Camo Form on a weapon component that will stay relatively cool.
• Use as a protection barrier against extreme heat and cold.
•Use Camo Form to wrap extra magazines.
•Use multiple camo patterns to achieve maximum camouflage; for additional dimension add twigs, leaves, and burlap into Camo Form folds.
Safety Precautions
• Re-calibrate all weapons after applying Camo Form.
• When wrapping a floating barrel, do not wrap tightly, then recalibrate the weapon upon completion.
DO NOT— Wrap the suppressor tip.
DO NOT— Wrap or obstruct moving parts such as the: trigger, ejection port door, magazine release, bolt stock, forward assist, rear takedown pin, safety selector, and charging handle.
DO NOT— Wrap the barrel of a weapon if it is used in full-auto mode for sustained firing.
DO NOT— Wrap over the sight guides of iron sights.
DO NOT— Fully wrap magazines so that it inhibits removal from firearm.
To Clean & Help Maintain Self-Cling Properties:
(1) Remove Camo Form from object and hand wash with soap and warm water.
(2) Rinse thoroughly and air dry.
Storage
Store Camo Form in sealed plastic bag away from direct sunlight and extreme heat.